CDG-500 - Agilent CDG-500
Pro více informací, prosím, kontaktujte prodejce:
- Zbyněk Ondra, BA (Hons)
- +420 736 473 797
- zbynek.ondra@labtech.eu
Technická specifikace
| Measurement range (full scale) | Torr | 1000 | 100 | 10 | 1 |
| Pa | 133,322 | 13,332 | 1,333 | 133 | |
| mbar | 1333 | 133 | 13,3 | 1,3 | |
| Accuracy* | % of reading | 0.2 | 0.2 | 0.2 | 0.2 |
| Temperature effect | |||||
| on zero | % F.S./°C | 0.005 | 0.005 | 0.005 | 0.015 |
| on span | % of reading/°C | 0.01 | 0.01 | 0.01 | 0.01 |
| Resolution | % F.S. | 0.003 | 0.003 | 0.003 | 0.003 |
| Pressure, maximum | kPa (absolute) | 400 | 260 | 260 | 260 |
| Lowest reading | % F.S. | 0.01 | |||
| Lowest suggested reading | % F.S. | 0.05 | |||
| Lowest suggested control pressure | % F.S. | 0.05 | |||
| Temperature | Operation (ambient) | Bakeout (at flange)** | Storage | ||
| 5 to 50 °C | ≤ 110 °C | –40 to 65 °C | |||
| Supply voltage | 14 to 30 VDC | ||||
| Power consumption | ≤ 1 W | ||||
| Output signal (analog) | 0 to 10 VDC | ||||
| Response time | 30 ms | ||||
| Degree of protection | IP30 | ||||
| Electrical connection | D-sub, 15 pole, male | ||||
| Setpoints*** – Two (2) setpoints, SP 1 and SP 2 | Relay Contact | Hysteresis | |||
| 30 VDC; ≤ 0.5 ADC | 1% of F.S | ||||
| Materials exposed to vacuum | Aluminum oxide ceramic (Al2O3), Vacon 70****, stainless steel (AlSl 316L*****) AgCuTi hard solder, sealing glass | ||||
| * Non-linearity, hysteresis, repeatability at 25 °C ambient operating temperature without temperature effects after 2 hours operation | |||||
| ** Non operating | |||||
| ***CDG-500 setpoint versions only | |||||
| **** 28% Ni, 23% Co, 49% Fe | |||||
| ***** 18% Cr, 10% Ni, 3% Mo, 69% Fe | |||||
Fotogalerie
Ke stažení
Dokumenty ke stažení
Máte dotaz?
LABTECH s.r.o © 2014, Pracoviště Telnice, K nádraží 191, Telnice 664 59, Tel: +420 511 192 927, Fax: +420 543 210 115, info@labtech.eu